Air Compressor Motor

Air Compressor Motor

Air compressor motor, Used for indoor environments with ambient temperatures below 40 ℃, low dust, no corrosive gases such as steam, acid, alkali, and explosive gases. The protection level of the motor's casing is IP00, and the cooling method is IC01. If other protection levels and cooling...

Product Introduction

Air compressor motor, Used for indoor environments with ambient temperatures below 40 ℃, low dust, no corrosive gases such as steam, acid, alkali, and explosive gases.
The protection level of the motor's casing is IP00, and the cooling method is IC01. If other protection levels and cooling methods are required, they can be negotiated with the user. The structure and installation type of the electric motor can be made into IM7311 and IM5710 according to the matching requirements of the compressor, or produced according to the matching requirements.
The rated voltage of the air compressor motor is 6000 volts, and it can also be made into 10000 volts. The allowable voltage deviation range is ± 5%. The rated frequency of the power supply is 50Hz, and the rated power factor is 0.9 (leading). From the collector ring end, the motor rotates clockwise. The direction of motor rotation can be changed as needed, but the fan blades of the motor should be adjusted accordingly.
The rated power level of this series of motors is 250 kW,320kW,350kW,400kW,500kW,550kW,630kW,800kW,1000kW,1120kW,1250kW,1400kW,1600kW,1800kW,2000kW,2000kW,2500kW,2800kW,3200kW,3600kW,4000kW Wait. The rated speed levels of the electric motor are 500RPM/min, 428RPM/min, 375RPM/min, 333RPM/min, 300RPM/min, and 250RPM/min
The excitation system of the Air compressor motor adopts a static thyristor excitation device. This motor allows direct starting at full voltage, and can also be started at reduced voltage when the grid capacity does not allow full voltage starting.
The motor has a welded steel plate base and chassis; Protection level IP00, cooling method IC01 fan self cooling, can also be made into IC37 duct ventilation, installation type IM7311 or IM5710, no shaft and base bearings, rated type S1, stator winding wiring method Y connection, insulation level F or above.
The stator of the Air compressor motor is made of 0.5mm thick low loss silicon steel sheets stamped and laminated into fan-shaped plates. The iron core has directional ventilation slots, and the stator winding uses molded double-layer stacked short torque coils with insulation level F;

Air Compressor Motor3

Air Compressor Motor4

Hot Tags: air compressor motor, China air compressor motor manufacturers, suppliers, factory, low noise motor, motor for freezers, motor for microwave ovens, motor for office equipment, motor for robotics, power saving motor

Send Inquiry

Home

Phone

E-mail

Inquiry

Bag